Page 7
If using the included booster
mounting bracket, remove
the booster from the bracket.
Fasten bracket to wall, then
snap booster back into bracket.
TIP
4. Fasten bracket to roof. Make sure fastener holes and fastener heads are
properly sealed.
5. Route the cable to where it will enter the vehicle.
6. Drill an appropriately sized hole and feed the cable into the vehicle.
7. Seal the roof hole so it is completely waterproof (inside and outside).
Fasten cable to roof every 12-18 inches.
8. Inside, place the booster in desired location or install the booster to a wall.
Connect cable to the booster.
9. Connect inside antenna cable to booster. Place inside antenna in position
as far from outside antenna and booster as possible.
10. Plug booster into power source.
Make sure to avoid any cabling, pipes, etc. that may be
damaged by drilling in step 6.
To Next Page
Loading...
