KING UC1000 - Satellite Service Chart; Service Options and Satellite Mapping

DISH only: For automatic satellite switching, KING recommends using
a DISH model 311 receiver for DISH SD. For DISH HD and SD, you can
use receiver models ViP211z, ViP211k, ViP211, and 411, but we highly
recommend using Tailgater mode with these receivers for simplied operation
with the receiver’s built in Tailgater interface (see section 3 to choose Tailgater
Mode).
DISH and Bell TV: If you do not have a clear view of the satellites, the
switch will not load correctly.
The SW21 and SW64 switches are a receiver software conguration that is
loaded into the receiver after successfully running a check switch test with the
dish locked on and congured for the appropriate service.
This one time procedure will not need to be repeated after successful
installation, unless:
a) check switch test is run again while the receiver is connected to a home
dish system.
b) check switch test is run when the receiver is not connected.
c) you travel outside your coverage area and recongure the antenna for a
different service.
d) you are parked in an area where the selected satellites are blocked, but
are able to select alternate satellites and get signal.
1. Turn on the TV and satellite receiver.
2. Press POWER to turn on the controller.
Wait for the lights to stop ashing and for the COAX CONNECTION light to
remain on.
3. Press SCAN.
The antenna must locate all of the appropriate satellites before successfully
completing the search process so it can properly congure your receiver.
After the antenna acquisition process is complete, specic SCAN
PROGRESS lights will turn on to indicate which satellites have been
found (see chart in section 5).
If you congured the antenna for DISH HD and SD and the antenna
cannot acquire the 110, 119, and 129 satellites, you may need to
congure the antenna for DISH HD and SD Alternate (section 3).
DISH AND BELL TV RECEIVER CONFIGURATION