4. On the receiver remote, press MENU, 6, 1, 1.
5. Highlight “Check Switch.”
Press SELECT on your remote.
NOTE: Some receivers may prompt you to select “Check Switch”
a second time to initiate the test.
Screen graphics may vary.
6. Make sure “SuperDISH”
and “Alternate” boxes
are NOT selected.
Not all receivers will display
a screen with options that
include “SuperDISH” and
“Alternate” boxes.
7. Highlight “Test.”
Press SELECT on your remote.
The receiver will perform a check switch test. This process can take a little
while so PLEASE BE PATIENT.
8. When test is complete, a screen similar to one on the next two pages should
appear. After screen verication, continue with check switch test procedure
steps 9-11 located after screen verication graphics.
Because receivers are always changing, screen graphics may vary.
Do not block signal to the antenna during this time. The antenna
requires a direct line of sight to the satellite.
To Next Page
Loading...
