Kingfisher FPGTP25-2 - Page 35

Operation
General operation
>
before each use. Do not use the product if it is damaged or
shows wear.
> Double check that accessories or application tools are
properly fixed.
> Check the fuel level, refill if necessary.
> Always hold the product on its handles. Keep the handles
dry to ensure safe support.
> Ensure that the air vents are always unobstructed and
clear. Clean them if necessary with a soft brush. Blocked
air vents may lead to overheating and damage the product.
> Switch the product off immediately if you are disturbed
while working by other people entering the working area.
Always let the product come to complete stop before
putting it down.
> Do not overwork yourself. Take regular breaks to ensure
you can concentrate on the work and have full control over
the product.
Check the product as well as accessories for damage
Starting/Stopping
Cold Start
>
cutting attachment does not touch the ground or any
objects.
> Set the ignition switch (12b) to the “I” position (Fig. 12a).
> Depress the primer (7) until fuel is visible and move the
choke lever (8) to its “ CLOSE” position (Fig. 12b).
> Press the throttle interlock [12a] and throttle control (12c),
hold them in position.
> Hold the product stable and pull the recoil starter
handle(11) slowly until you feel a definite resistance
(starter engaged) and then give it a brisk, strong pull.
Repeat until the engine starts. (Note: If the engine cannot
start, pull the choke lever downward to" OPEN" position
and repeat this step until the engine starts.) (Fig. 12c).
> Release the throttle interlock (12a) and throttle control
(12c)
Place the product on a flat, stable surface. Ensure that the
In more detail...
34
FPGTP25-2
EN