Kingfisher FPLMP129 - Draining Engine Oil; Valve Play; Spare Parts;Replacement Parts

40
FPLMP129 FPLMP129
In more detail . . .
3. Check the oil level frequently while lling. Wipe off oil dipstick and insert it into the
tank opening without tightening the cap, and then remove the dipstick again.
4. The oil level must be between the oil level markings (approx. 400 ml). Add more oil
if necessary. Do not overll.
5. After lling oil, wait 1 minute and then recheck the oil level.
6. Wipe the spilt oil with a soft cloth and reattach the oil tank cap (14).
Draining engine oil
NOTE: Drain the oil every 50 hours of operation of every 6 months.
1. Unscrew the oil tank cap (14).
2. Place a suitable container next to the product.
3. Tilt the product to the side to drain the oil into the oil container.
4. Clean the product from the oil spills afterwards.
Carburettor
The carburettor is preset by the manufacturer. Should it be necessary to make any
changes, contact an authorised service centre or a similarly qualied specialist. Do not
attempt to make any adjustments by yourself.
Mufer
Should it be necessary to modify or replace the mufer, contact an authorised service
centre or a similarly qualied specialist. Do not attempt to make any adjustments by
yourself.
Valve play
Have a qualied specialist check and adjust the valve play. Details for the specialist:
IN = 0.1-0.15 mm, EX = 0.15-0.2 mm.
Spare parts/Replacement parts
The following parts of this product may be replaced by the consumer. Spare parts are
available at an authorised dealer or through our customer service.
Description Model no. or Specication
Blade (25) SMV 1181206
Spark plug (8a)
LD K7TC (Gap of electrodes: 0.7-0.8 mm)
or other model with same specications
Repair
This product does not contain any parts that can be repaired by the consumer. Contact
an authorised service centre or a similarly qualied specialist to have it checked and
repaired.
Storage
NOTE: Good storage conditions are important for keeping your product trouble-
free.
1. Stop the engine and disconnect the spark plug connector (8).
2. Clean the product as described in the “Cleaning” section.
3. Store the product and its accessories in a well-ventilated dry storage area.
4.
Always store the product in a place that is inaccessible to children. The ideal storage
temperature is between 10 °C and 30 °C.
5. We recommend using the original package for storage or covering the product with
a suitable cloth or enclosure to protect it against dust.
6. For long-term storage (more than 30 days), drain the fuel tank (6) as described in
previous chapter.
7. If you plan to store the product with fuel and oil, it is important to reduce the risk of
petrol vapours ignition. To reduce that risk, store the product in a well-ventilated dry
storage area, away from any other products that operate with a ame e.g. water heater.
Transportation
1. Stop the engine and disconnect the spark plug connector (8).
2. Adjust the height to the highest position as described in the “Cutting height adjustment”
section.
3. Attach transportation guards, if applicable.
4. Always move the product by the upper handle bar (2).
5. If a suitable loading ramp is not available, ask another person for assistance when
loading the product on a vehicle.
6. Protect the product from any heavy impacts or strong vibrations which may occur
during transportation in vehicles.
7. Secure the product with tie-down straps to prevent it from slipping or falling over.
Care and maintenance
3663602423270-GB-V04.indd 40 27/9/2018 10:07