Kingfisher NMHT450 - Product Functions and Operation; Intended Use; Switching On and Off

EN
16
EN
Product functions
In more detail...
NMHT450
Product functions
Intended use
This electric hedge trimmer NMHT450 is designated with a rated power input of
450 Watts.
The product is intended for cutting and trimming of hedges, bushes and shrubs in
domestic gardens. The maximum cutting capacity must be observed. Do not cut
branches exceeding the stated maximum capacity.
The use of this product in case of rain or humid environment is prohibited.
For safety reasons it is essential to read the entire instruction manual before rst
operation and to observe all the instructions therein.
This product is intended for private domestic use only, not for any commercial
trade use. It must not be used for any purposes other than those described.
Switching on/off
1. Ensure the cutting device (blade) (1) does not touch any objects. Remove
the blade cover (11) from the cutting device (blade) (1) before switching the
product on.
2. Hold the product with one hand on the front handle (4) and the other hand on
the rear handle (6).
3. Squeeze the safety switch (3) and hold it in position (Fig. 4, step 1).
4. Squeeze the on/off switch (7) to switch the product on (Fig. 4, step 2).
5. Release either the on/off switch (7) or the safety switch (3) to switch the
product off.
1.
2.
6
4
3
1
7
Fig. 4
No name_MNL_NMHT450_Electric Hedge Trimmer_GB_V3_210918_UK.indd 16 9/22/21 4:31 PM