Kingfisher NMHT450 - Setup and Power Connection

EN
NMHT450
Getting started...
14
Before you start
Setup
1
11
Fig. 1
NOTE: Always attach the blade cover (11) when the product is not in
use, for storage and transportation.
To attach the blade cover (11), align and push the blade cover onto the
cutting device (blade) (1).
Connection to power supply
NOTE: The product is equipped with a power cord with the length of
7 m. If a proper extension cord is required for operation. The
extension cord must be suitable for outdoor use with sockets
protected against water splashing! Ensure the extension cord is of the
proper size and type for your product (≥ 1.0 mm²)!
Always use a residual current supply (RCD) protected supply.
1. Double the power cord (10) back, about 60 cm from the power guard and lead
the loop through the hole of the rear safeguard (8) (Fig. 2).
2. Pull it over the cord retainer (9) and gently tug on the power cord (10) to
ensure that it is rmly secured (Fig. 3).
No name_MNL_NMHT450_Electric Hedge Trimmer_GB_V3_210918_UK.indd 14 9/22/21 4:31 PM