Kingfisher NMHT450 - General Operation and Checks

EN
17
EN
In more detail...
NMHT450
Product functions
General operation
1. Check the product, its power cord and plug as well as accessories for damage
before each use. Do not use the product if it is damaged or shows wear.
2. Double check that the accessories and attachments are properly xed.
3. Always hold the product on its handles. Keep the handles dry to ensure safe
support.
4. Ensure that the air vents are always unobstructed and clear. Clean them if
necessary with a soft brush. Blocked air vents may lead to overheating and
damage the product.
5. Switch the product off immediately if you are disturbed while working by other
people entering the working area. Always let the product come to complete
stop before putting it down.
6. Do not overwork yourself. Take regular breaks to ensure you can concentrate
on the work and have full control over the product.
WARNING! Ensure the power cord or the extension cord will not touch
the cutting device (blade) (1) during operating!
Danger of electric shock!
Trimming times
green leaf hedges June to October
evergreens April and August
conifers and other fast growing shrubs every 6 - 8 weeks
Trimming
NOTE: Try to keep the cutting device angled at approximately 15° to
the cutting surface.
1. Ensure that no people or animals are in the work area.
2. Cut and remove branches exceeding the cutting capacity of this product
using a proper pruner before operation.
3. Always hold the product rmly with both hands on front handle (4) and rear
handle (6). Never operate this product using only one hand.
4. Do not rush and do not attempt to cut too much with one stroke of the cutting
device.
No name_MNL_NMHT450_Electric Hedge Trimmer_GB_V3_210918_UK.indd 17 9/22/21 4:31 PM