Kingfisher NMRS1500 - Page 5

5
NMRS1500
Getting Started . . .
Maintenance and storage
1. Keep all nuts, bolts and screws tight to be sure the equipment is in safe working
condition.
2. Check the debris collector frequently for wear or deterioration.
3. Replace worn or damaged parts for safety.
4. On machines with multiple time assemblies, take care as rotating one time assembly
can cause another time assembly to rotate.
5.
between moving time
6. Always allow the machine to cool down before storing.
7. When servicing the time assembly be aware that, even though the power source
is switched off, the time assembly can still be moved.
8.
Replace worn or damaged parts for safety. Use only genuine replacement parts
and accessories.
9. When the machine is stopped for servicing, inspection, or storage, or to change an
accessory, shut off the power source, disconnect the machine from the supply and
make sure that all moving parts are come to a complete stop. Allow the machine
to cool before making any inspections, adjustments, etc. Maintain the machine
with care and keep it clean.
10. Store the machine out of the reach of children.
Additional safety warnings
WARNING! Beware of sharp tines. Tines continue to rotate after the motor
is switched off.
1. Do not use the product if the cords are damaged or worn.
2.
Do not to connect a damaged cord to the supply or touch a damaged cord before it
is disconnected from the supply. A damaged cord can lead to contact with live parts.
3.
for outdoor use and not lighter than H05VV-F or H05RN-F, 2x1.0 mm² and its
length max 75 m.
Recommendation for class II products
1.
The product should be supplied via a residual current device (RCD) with a tripping
current of not more than 30 mA.
2. Avoid using the machine in bad weather conditions especially when there is a
risk of lightning.
Safety information
3663602627173_MNL_GB_V03.indd 5 30/3/2023 11:49 AM