3. Install the D2 dash cam on the windshield.
Firstly, clean the windshield with a dry cloth. Secondly, take off the film of the
suction cup and press the suction cup onto the windshield to make sure there is
no air inside the suction cup, and then rotate to secure the bracket.
Cable clip
4. Adjust the view angle of the dash cam to ensure a good view.
5. Connect the USB Power Cable into the USB power port of D2 Dash Cam,
then plug the Car Charger in the cigarette lighter in your car.
6. Connect the Rear Camera with the Extension Cable into D2 Dash Cam to
check whether the Rear Camera works well.
7. Install the Rear Camera.
Position 1: Install the Rear Camera on the rear windshield. The installation is easier.
Position 2: Install the Rear Camera near the license plate. Position 2 is highly
recommended. The rear image is crisp and clear for both rear viewing
and reversing guide.
To use the reversing guide function, please install the rear camera in position 2,
then connect the red trigger wire of the Rear Camera Extension Cable to the
positive lead of the vehicle reversing lamp.
Reversing Lamp
Reversing Lamp Positive Lead
Rear
Rear Camera
05 06
To Next Page
Loading...
