Installation Instructions
Model Number ZRB46
Zero Clearance Vented Gas Fireplace Heater
Stock #’s: ZRB46N, ZRB46NE, ZRB46LP, ZRB46LPE
Certified to: ANSI Z21.88-2009, CSA 2.33-2009, CGA 2.17-M91
Printed in Canada July 2, 2013 Part # 46ZRB-MAN
FOR YOUR SAFETY
Read this complete manual before beginning installation.
These instructions must be kept with the unit for future reference.
This appliance may be installed in an aftermarket permanently located, manufactured home (USA only) or mobile
home, where not prohibited by local codes.
This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for
use with other gases, unless a certified kit is used.
!WARNING: If the information in these instructions is not followed exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
!Warning: Improper installation, adjustment, alteration, service or maintenance can cause property
damage, personal injury or loss of life. Refer to this manual. Installation and service must be performed by
a qualified installer, service agency or the gas supplier.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
What To Do If You Smell Gas
Do not try to light any appliance.
Extinguish any open flame.
Do not touch any electrical switch.
Do not use any phone in your building.
Immediately call your gas supplier from a neighbor’s phone.
If you can not reach your gas supplier, call the fire department.
A Division of R-Co. Inc.
2340 Logan Avenue
Winnipeg, Manitoba, Canada R2R 2V3
-
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
This Appliance Is Only Approved With Kingsman Flex Vent System, Except When Using The Power Venting Option.
To Next Page
Need help?
General
