Kioti CK30 - Page 102

10-9PERIODIC SERVICE
1. Place the oil pan under the engine.
2. Remove the oil filter.
3. Put a film of clean engine oil on the
rubber seal of the new filter.
4. Tighten the filter quickly until it con-
tacts the mounting surface.
Tighten filter, by hand, an additional
half turn only.
5. After the new filter has been
replaced, the engine oil normally
decreases a little. Make sure that the
engine oil does not leak through the
seal and be sure to check the oil level
on the dipstick. Replenish the en-
gine oil up to the prescribed level if
necessary.
To avoid personal injury:
zz
zz
z
Be sure to stop the engine be-
fore changing oil filter cartridge.
zz
zz
z
Allow engine to cool down
sufficiently, oil can be hot and
can burn.
!!
!!
!
CAUTION
(1) Drain Plugs
(1) Oil Filler Plug (2) Gauge
(A) Oil level is acceptable within this range
1. To drain the used oil, remove the
drain plugs at the bottom of the trans-
mission case and differentials. Drain
the oil completely into a drain pan.
2. After draining reinstall the drain plug.
3. Fill with the new fluid to the upper
line of the gauge.
(See "LUBRICANTS" in Maintenance
Section)
4. After running the engine for a few
minutes, stop it and check the oil
level again; add oil to prescribed
level.
CHANGING TRANSMISSION
FLUID
704OA12C
704OA13C
To avoid personal injury:
zz
zz
z
Allow engine to cool down suffi-
ciently, oil can be hot and can burn.
!!
!!
!
CAUTION
zz
zz
z Do not operate the tractor im-
mediately after changing the
transmission fluid.
zz
zz
z
Run the engine at medium speed
for a few minutes to prevent dam-
age to the transmission.
IMPORTANT
Oil Capacity
CK25/30/35
CK25/30H/35H
27 (7.13 U.S.gal.)
30
(7.93 U.S.gal.)