10-10 CK25/30/35
REPLACING HYDRAULIC OIL FILTER
& TRANSMISSION OIL FILTER
1. Place the oil pan under the hydrau-
lic oil filter.
To avoid personal injury:
zz
zz
z Be sure to stop the engine be-
fore changing oil filter cartridge.
!!
!!
!
CAUTION
zz
zz
z
To prevent serious damage to
the hydraulic system, use only
a genuine KIOTI filter.
(1) HST Oil Filter
6. After running the engine for a few
minutes, stop it and check the oil
level again, add oil to the prescribed
level.
7. Make sure that the transmission fluid
doesn't leak through the seal.
8. HST model has both transmission
filter and HST filter.
(1) Hydraulic Oil Filter
HST Type
704OA15C 704OA16C
IMPORTANT
2. Remove the oil filter.
3. Place a film of clean transmission
fluid to the rubber seal of the new
filter.
4. Tighten the filter firmly until it con-
tacts the mounting surface. Then
tighten the filter, by hand, an addi-
tional half turn only.
5. After the new filter is in place, fill the
transmission up with oil to the upper
line of the oil gauge.
To Next Page
Loading...
