1. Make sure there is no hazardous
obstacle around the tractor.
2. Make sure the parking brake is set
(1) Depress the parking brake
pedal and pull the lever up
.
(Check that the parking brake
lamp on the gauge board illu-
minates)
(2) To release the parking brake
press the brake pedals again.
Make sure that the brake pedals
are fully depressed before pull-
ing the parking brake lever up.
IMPORTANT
(1) Parking Brake Lever (2) Brake Pedal
(A) Depressing (B) Pressing Up
Safety start system is applied:
Start condition (HST): Operator
on the seat + Pushing brake
pedal. (HST pedal, Rear PTO
and Mid PTO levers should be
in neutral position)
Start condition (Mechanical):
Operator on the seat + Apply
-
ing clutch pedal + Pushing
brake pedal. (Shuttle lever,
Rear PTO and Mid PTO levers
should be in neutral position)
Operation continuance condi
-
tion when operator leaves from
the seat: when parking brake
in on and range shift and Mid
PTO lever is in a neutral posi-
tion. In any other condition, the
tractor stops operation by it
self in 3 sec of time delay.
•
•
•
IMPORTANT
tb3O428A
To Next Page
Loading...
