(1) Key Switch
(A) Stop (B) ACC
(C) ON (D) Start
tb3O418A
6. Set the hand throttle lever into the
neutral position.
(1) Hand Throttle Lever
¡ “Increase” “Decrease”
7. Insert the key into the key switch
and turn it "ON" and maintain it un-
til the preheat lamp is turned off.
While pre-heating, the pre-heat
lamp on the dash board illumi-
nates.
It is normal that the charge warning
lamp and engine oil pressure warn-
ing lamps come on when the key is in
"ON" position before the engine start.
NOTE
Operating principle of auto pre-
heating system.
The glow plug lamp comes on
for 6 seconds and then goes off
when the key switch is turned to
the "Start" or "Stop" position.
The engine should be started
within 6 seconds after the glow
plug lamp goes off. After the en-
gine is started, post-heat is per-
formed for 15 seconds with the
key switch in the "ON" position.
The after-heating is a function
to keep the glow plugs activated
for approx. 15 seconds after
the engine is started in order to
enhance the engine combus-
tion performance and to reduce
harmful emissions right after en-
gine start.
tb3O430A
To Next Page
Loading...
