- 11 -
7. Pull only from the draw-bar. Use only a draw-bar
pin that locks in place. Pulling from the tractor rear
axle or any point above the axle may cause the
tractor to tip over.
8. If the front end of the tractor tends to rise when
heavy implements are attached to the three-point
hitch, install front-end weight. Do not operate the
tractor with it unbalanced.
9. Do not leave equipment in the raised position
when the tractor is stopped or unattended.
10. When installing or using an implement or other
attachment with the tractor, be sure to read the
“Specifications of Implement Limitations”.
11. Know your equipment and its limitations.
12. When using an implement, be sure to install the
proper ballast weight on the tractor.
13. Ensure any attached equipment or accessories
are correctly installed, and approved for use with
the tractor. Do not overload the tractor, operate and
maintain in accordance with the instructions is-
sued by the equipment or accessory manufacturer.
14. Remember that your tractor, if abused, can be dan-
gerous and become a hazard both to the operator
and to bystanders. Do not overload or operate with
attached equipment which is unsafe, not designed
for the particular task or is poorly maintained. Re-
fer to “specifications of Implement Limitations”
recommended by KIOTI Dealer, which outlines the
maximum loads for safe tractor operation.
15. When loading on a truck, securely fix a rugged
ramp with non-skids and check to see that there
are no people around before starting to load or
unload.
16. When loading or unloading, chock up or block up
the truck tires.
To Next Page
Loading...
