Kioti DS4510 - Checking Engine Oil Level (E)

7
7
-11
MAINTENANCE
H11O608A
4. Pull out the oil dipstick, clean it,
and then insert it into its original
position. Then, pull it out again
and check if the oil level is within
the specied range.
5. If the oil level is too low, add some
new oil so that the level is within
the allowable range.
(1) Oil Dipstick
(A) Upper Limit (B) Lower Limit
1. Check the engine oil daily.
2. Park the tractor on a level ground
and lower the implement.
3. If the engine was just running,
wait for approx. 5 minutes before
checking the oil level.

If oil level is low, do not run
engine.

Never add the oil over the up-
per limit.

Be sure to check the oil level
after installing hydraulic imple-
ment. Add the uid as needed.

Check the oil level with the cyl-
inders of an implement extend-
ed and check again with cylin-
ders retracted. Add the oil to
adjust average oil level in the
range of the oil limit (upper or
lower).
H61O706A
CHECKING ENGINE OIL LEVEL
(E)
(1) Engine Oil Filler Plug (2) Oil Dipstick
(A) Oil Level is Acceptable Within This Range
IMPORTANT
To avoid personal injury:

Be sure to stop the engine be-
fore checking the oil level.
CAUTION
M50-EU-07.indd 11 2009-09-28 오후 6:11:27