1. Water and dust in fuel are accumu-
lated in the lter. Remove the plug
from the bottom of the fuel lter to
drain any impurities.
2. Tighten the lter with a hand (not a
tool) after drainage.
3. Start the engine and check for fuel
leakage.
REPLACING FUEL FILTER
1. Wipe the surface of the fuel filter
clean.
2. Unscrew the plug on the bottom of
the fuel lter to drain fuel.
3. Remove the fuel lter.
4. Remove foreign materials, such
as dirt, thoroughly and replace the
fuel lter with a new one.
1. Make sure that the amount of fuel
in the fuel tank is sufcient.
2. If there is air in the fuel lter, turn
the filter cock to the air side and
turn the ignition key to turn the
start motor. Then, the air in the l-
ter port is discharged through the
bleeding hose as shown in the g-
ure.
BLEEDING FUEL SYSTEM (AJ)
(1) Pump (2) Air Plug
TE1O733A
To Next Page
Loading...
