46
●IG2000\IG2000S
交流插座
点火器
直流插座
smart开关
接地端
7.2 Inspection
a. Control panel
● AC receptacle
Check the electrode contact disk inside receptacle, if it is burnt or the discolored, replace it.
● DC receptacle
Connect both terminals of the receptacle with a jumper wire to short. There must be continuity
between the lead wire terminals with the circuit protector ON. Replace the DC receptacle if there
is no continuity.
● Smart switch
There should be continuity with the switch ON, and no continuity with the switch OFF.
Igniter
AC receptacle
Ground terminal
Smart throttle switch
DC receptacle
To Next Page
Loading...
Need help?
General
