3 Operation of components
3.5 Operation of cab
▆Door ON/OFF
1. Unlock the door with key and hold the handle
to open the door from outside. Push the door to
the end and fix it.
Handle of door
2. Pull the lock and open the door from inside.
Lock Fixed pull-rod
3. Work the fixed pull-rod to release the lock and
turn off the door.
4. Lock the door if driver leaves the loader for a
long time.
▆Cab lamp
Cab lamp lights when both start key and button of
cab lamp are at ON. Cab lamp is located at the
ceiling of cab. It can be used as a switch to turn
on or off the illumination too.
▆Buttons of windshield wiper and cleaner
Press down the button of windshield wiper to
trigger the motor when start key is at ON.
Operate the button of windshield cleaner to
activate the spraying cleaner. Even if start key is
at OFF, spraying cleaner can work as described
above.
●Do not operate the button of windshield cleaner
if container of cleaning agent is empty.
Otherwise it may damage the spraying pump.
●Windshield may be damaged if it is wiped
without cleaning agent. Please spray the
cleaning agent in advance.
●Check if rubber of windshield wipe is attached
on the glass before usage in cold winter. If it
is frozen, do not work the windshield wiper to
avoid the damage of motor.
Buttons of cab lamp, windshield wiper and
cleaner are located in the fixed panel of operating
lever of bucket one after another.
▆Safety belt
1. Adjust the length of safety belt and fasten it.
Fasten the safety belt reliably when you drive the
loader.
16
To Next Page
Loading...
Need help?
General
