• Route the wire harnesses properly so that they do not contact sharp edges and corners and the
end of the bolts and screws on the body.
• If a wire harness must contact the end of the bolts or screws or sharp edges and corners, protect
the contact part of the harness with a loom or by winding with electrical insulating tape. If the wire
harness has a grommet, set the grommet securely.
• Take care not to pinch the wire harnesses during installation of a part. If a wire harness has
damaged insulation, repair by winding with electrical insulating tape.
• When using an electrical tester like a volt/ohm meter or clamp on meter, read the manufacturer’s
operating instructions carefully before operating the tester. Be sure that the tester battery is fully
charged and the meter is functioning properly
2.5 Serial Number and Bar Code Location
The engine serial number is stamped beside the engine oil drain plug. This number is used to identify the
specific engine version.
Engine serial number
The bar code is used by Coast Distribution to determine production date and warranty administration.
The bar code is found in three locations:
on the generator, on the packing carton
and on the inside cover of the
operator’s manual.
4
To Next Page
Loading...
