Note: You can enable or disable wired clone function by PC
software. Once this function is disabled, the radio cannot enter
into wired clone mode.
The default setting: Disabled.
Troubleshooting
No.
1
2
3
Problem
The radio cannot be
switched on or no
display after being
switched on.
Cannot talk to or
hear other group
members.
Other voices from
non-group members
Causes and Solutions
* The battery power may be
insufficient. Please recharge or
replace the battery pack.
* The battery pack may not be
installed properly. Please remove
the battery pack and install again.
* Make sure the CTCSS/DCS
signal is the same as that of your
group members.
* The radio is out of effective
communication range.
* Change the CTCSS/DCS signal,
and make sure to change the
4
5
are heard on the
channel.
The communication
range is too short.
The battery power
consumes quickly
after charging.
CTCSS/DCS signal of all radios in
your group.
* Make sure the antenna is well
connected.
* Make sure the antenna is the
original supplied one.
* Check if the battery power is in
normal state.
* Ask your local dealer to adjust the
squelch level.
* The battery life is finished. Please
replace it with a new battery pack.
Major specifications
General Specifications
Frequency (MHz)
RF power
No. of channel
Frequency stability
Power supply
External dimension
Weight
Intermodulation
136 – 174MHz 400 – 470MHz
≤5W ≤4W
16(15+S)
± 2.5ppm
DC 7.4V
60mm × 210mm × 34mm
223g (with battery and antenna)
> 60dB
Tx Part
Tx clusters and harmonics
Max. deviation
Rated audio deviation
< -70dB
± 5K (W) / 2.5 (N)
≤8%
Rx Part
Rx sensitivity
Max. audio power
SINAD
Rated audio deviation
≤ 0.2μV(12dB SINAD)
≥ 500mW
≥45dB
≤5%
Status setting (by the dealer)
Model: Serial No.:
1. Channel setting
Channel No. Tx frequency Rx frequency CTCSS/DCS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
To Next Page
Loading...
Need help?
General
