Plug the power adapter into an
applicable AC outlet and connect
the power adapter to the battery charger. Green LED lights.
Preparation
Charging the Battery
Insert the battery to be charged or the radio with the battery
into the charger slot.
Make sure the battery is well connected with the charger.
Then Red LED lights,which indicates that the charging starts;
Green LED lights, indicating the charging
is finished.
Note:
The radio battery is not fully charged before shipment.
Before the initial use, please charge the new battery.
KB-260 Li-ion battery of Kirisun is applicable to this radio.
There is a built-in protective circuit in KB-260. When the
power is low, it will cut off the power supply immediately. If
you insert the battery on the charger, Red LED on the charger
lights. Pre-charging for 1~5 minutes, the battery begins to
be charged.
Do not reverse the battery pole or discard the battery in
the fire.
Do not disassemble the cover of the battery by yourself.
KBC-260 Charging State Indication
Indication
Operation
state
No battery
Pre-charging
Quick-charging
Full charging
Short circuit
protection
High temperature
protection
High voltage protection
Low voltage protection
Red
Charging
ON
ON
Green
Power supply
ON
ON
Yellow
Abno rmal
ON
ON
ON
ON
Note
It will be back to
normal when
disabled short
circuit protection.
Recovered when
power off.
Installing/Removing the Battery
Match the two bulges at the bottom of the battery pack with
the corresponding slots
at the rear bottom of the
radio.
Press the top part of the battery towards the radio to lock it
in place until a click is heard.
To remove the battery pack, press the battery latch
backwards, and then remove the battery away from the radio.
To Next Page
Loading...
Need help?
General
