Work Alone:Work as single repeater, not networking with other repeaters.
Connect Working Mode:If exceed one single repeater’s coverage, this mode enables the
repeater to connect with other repeaters to expand the coverage.
Group Call Hang Time:When a terminal radio initiates a group call, and no PTT presses,
repeater shall hang on for a period of time. During this time, the channel is being taken up, and
communication is regarded still going, no accept to other signal relay. If any presses PTT, then the
hang time recounts. Once the hang time is over, this communication is over too, channel will be
released.
Value Range: 0~7000ms, the step is 500ms, the default value is 4000ms.
Individual Call Hang Time: When a terminal radio initiates an individual call and no PTT presses,
repeater shall hang on for a period of time. During this time, the channel is being taken up, and
communication is regarded still going, no accept to other signal relay. If any presses PTT, then the
hang time recounts. Once the hang time is over, this communication is over too, channel will be
released.
Value Range: 0~7000ms, stepping is 500ms, the default value is 4000ms.
Emergency Call Hang Time: When a terminal radio initiates an emergency call and no PTT
presses, repeater shall hang on for a period of time. During this time, the channel is being taken
up, and communication is regarded still going, no accept to other signal relay. If any presses PTT,
then the hang time recounts. Once the hang time is over, this communication is over too, channel
will be released.