Value Range：0~7000ms, stepping is 500ms, the default value is 4000ms.
Calling Hang Time: When a call ends, the repeater will hang on for a period of time, during this
time, when a terminal radio presses the PTT, no need to build connect again, just communicate
directly.
Value Range: 0~7000ms, the stepping is 500ms, the default value is 4000ms.
Network Setting: When networking, different repeaters can address to build a connecting by
setting the network parameters.
Local IP: The IP address of repeater, like 192.168.1.100.
Local Port: The repeaters use the UDP local port to connect to the server. The range of the port
is 0~65535.
Server IP: When networking, the IP of the server that repeater connects to.
Server Port: The repeater uses TCP server, TCP server connects needs a specific server port.
The range value of the port is from 0~65535.
Gateway IP：When networking, the gateway IP that repeaters interconnect to each other.
Transmit Frequency: To set the transmit frequency in the current channel. The range cannot
exceed what the repeater limits.
Receive Frequency: To set the receive frequency in the current channel. The range cannot
exceed what the repeater limits.
Power: To select current channel’s RF power level
Fan Control: User can set the Fan Work Threshold, Power Amplifier Protect Threshold and
To Next Page
Loading...
