27
3.2.1 Electric Starting Starting Without Cold-Start
Aid
3.2 Starting 3. Engine Operation
Before starting, make sure that
nobody is standing in the
immediate vicinity of the
engine or driven machine.
After repair work;
Check that all guards have been replaced
and all tools have been removed from
the engine.
When starting with flame glow system,
do not use any other starter substance
(e. g. injection with start pilot).
Caution: If the speed regulator has been
removed for any reason, the engine must
not be started under any circumstances.
Disconnect the battery.
Do not actuate the starter for more than
10 seconds. If the engine does not start
wait a minute then try again.
If the engine does not start after two
attempts, refer to the Diagnosis Chart
(see 7.1)
* Where possible, disengage the
Caution: If the speed regulator has
been clutch to separate the engine
removed for any reason, the engine
from any driven equipment. must not
be started under any
* Move speed control lever 1 to
circumstances. idle position.
* Insert key.
- Position OFF = no operating voltage.
* Turn key clockwise
- Position ON = operating voltage
- Charge Lamp comes on.
(If applicable)
* Turn key further clockwise against
spring pressure.
- Position 2 = start
* Release key as soon as engine fires
- Charge Lamp goes out. (If applicable)
OFF
ON
SRART
Charge Lamp
Stopping
Lever
Accelerating
Lever
To Next Page
Loading...
Need help?
General
