6.3 Air Cleaner Oil Change & Cleaning Procedure
Step 1 - Loosen air filter clamps, separate oil bath bowl & filter element.
Step 2 - Dispose old oil from bowl & wipe out dust particles from bowl by use of clean cloth.
Step 3 - Fill new recommended oil into the oil bath bowl.
Step 4 - Clean filter elements with diesel or kerosene & reinstall. If filter elements are
damaged, replace with new one.
Step 5 - Reinstall oil bath bowl & tighten filter bowl clamps.
Note: Operating engine with dusty oil or damaged filter element causes engine
performance.
6.4 Transmission Oil Change Procedure
x Place MINT on flat surface & keep oil container
tray at bottom of gear box to collect old oil.
• Drain out transmission oil by removing
transmission drain plug and oil filer cap
• After complete oil drain out, reinstall the drain
plug securely & fill recommended transmission
oil into the gear box. Use funnel to avoid oil
spilling.
• Use oil filler gun or oil applicator to avoid oil
spilling.
• After complete of process, reinstall oil filler
cap.
•To
check transmission oil level, remove oil level filler cap provided at top side of gear box assy.
• When it drops near the low mark add oil, but do not fill above the full mark.
•Put
the dipstick back into the filler hole and twist the stick around so the flat side is toward the
cente
r of the transmission gearbox
6.5 Lubrication Specification Chart
USE ONLY KOEL RECOMMENDED OIL & LUBICANTS
Lubricants Type Specifications Quantity Replacement
Engine Oil SAE 15W-40, CF-4 1.65 lit Every Service
Transmission Oil SAE 80W-90, GL-4 2.2 lit 200 Hrs or 5 months
Air Cleaner SAE 15W-40, CF-4 15-20 ml Every Service
.,5/26.$52,/(1*,1(6/,0,7('
$.LUORVNDU*URXS&RPSDQ\
To Next Page
Loading...
