KIT PE-14 - Power Packet Configuration Utility; Launching the Utility

KIT CO.,LTD.
29
User’s Manual
Chapter 4 : Power Packet Configuration Utility
Introduction
The PowerPacket Configuration Utility for PowerPacket products enables
the user to find PowerPacket devices on the powerline network, measure
data rate performance and ensure privacy by setting a user defined network
private password.
This utility gives you the capability to set up a network password on the local
device connected to the computer where the utility is running. It gives you as
well, through the advanced option, the capability to set up a network
password remotely on other PowerPacket devices through the powerline.
It is recommended that the same PC chosen for initial execution of this utility
remain the PC of choice for subsequent network encryption updates.
Network setup information is stored on the PC and is used to facilitate
follow-on network encryption sessions.
Before running this utility, make sure that a PowerPacket device is properly
installed and connected to your computer.
Running the utility
To run the utility, double click the PowerPacket Configuration Utility icon
on your desktop.
The wizard has five different dialog screens options accessible through the
following tabs :
Device, Network, Security, Advanced and About. In the coming sections,
we will explain the purpose and the functionality of each of them.
NB: As a general rule that applies to dialog screens, pressing:
The OK and Cancel buttons means “ exit utility ”