Getting Started
Before first use
• Unpack the appliance but keep all packaging materials until you have made sure your new juice
extractor is undamaged and in good working order. Plastic wrapping can be a suffocation hazard
for babies and young children, so ensure all packaging materials are out of their reach.
• Fully unwind the cord and inspect it for damage. Do not use the appliance if anything has been
damaged. In such a case, contact our after sales support line for advice on examination, repair or
return of the damaged product.
• Read this manual to familiarise yourself with all the parts. Pay particular attention to the safety
instructions on the previous pages.
• Make sure the appliance is disconnected from the power supply.
• Holding the rim of the filter with you fingers, lift the stainless steel filter out of the juice collector.
Then lift the plastic juice collector off the motor unit.
• Wash all detachable parts with a soft cloth or sponge in warm water and a little washing-up
detergent to remove any dust or other remnants from the manufacturing process.
CAUTION! Take care to avoid injury from the sharp blades at the bottom of the filter.
• Rinse the parts with clean water and dry.
• When all parts are thoroughly dry, assemble the unit as follows.
Assembly
• Place the juice collector into the appliance — see (1) in Fig. 1 below.
• Tilt the motor unit slightly to attach the pulp container to the appliance, fitting the top end
underneath the pulp spout first, then lining up the bottom end — see (2) in Fig. 1 below.
1.
To Next Page
Loading...