6
ELECTRICAL REQUIREMENTS
WARNING
Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or electrical
shock.
Voltage: 220-240 VAC
Frequency: 50 - 60 Hz
Wattage: 180 W
NOTE: If the plug does not fit in the outlet,
contact a qualified electrician. Do not modify
the plug in any way. Do not use an adapter.
Do not use an extension cord. If the power
supply cord is too short, have a qualified
electrician or service technician to install an
outlet near the appliance.
The cord should be arranged so that it will not
drape over the countertop or tabletop where it
can be pulled on by children or tripped over
unintentionally.
ASSEMBLING THE BLENDING ARM
Before first use, clean all parts (see “Care and
Cleaning” section).
IMPORTANT: Always unplug the Hand
Blender, before attaching or removing parts.
1. Insert the Blending Arm into the Motor
Body and twist until it clicks to lock in
place.
2. If using a Pan Guard, place it on a flat
surface.
To insert the Pan Guard, angle the
Blending Arm to one side of the Mounting
Clip. Then, gently pull the other Mounting
Clip outward and push down the Blending
Arm. Ensure the Mounting Clips are
secured into place.
NOTE: U.S. patented removable Pan Guard
to help protect your cookware.
To Next Page
Loading...
