8
NOTE: When properly adjusted, the Flat Beater will not strike on the bottom or side of
the Bowl. If the Flat Beater or the Wire Whip is so close that it strikes the bottom of the
Bowl, the Beater or Whip may wear.
Adjust so Flat Beater just clears bottom
surface of Bowl when in lifted position by
turning screw counterclockwise to raise
the Bowl and clockwise to lower the Bowl.
Just a slight turn is all that is required: the
screw (A) will not rotate more than 1/4 turn
(90 degrees) in either direction.
(The full range of adjustment is 1/2 turn, or
180 degrees.)
3
Raise Bowl
Lower Bowl
PRODUCT USAGE
BEATER TO BOWL CLEARANCE
Your Stand Mixer is adjusted at the factory so the Flat Beater just clears the bottom of
the bowl. If, for any reason, the Flat Beater hits the bottom of the bowl or is too far away
from the bowl, you can correct clearance easily.
Turn the Stand Mixer to “0” (Off) and
unplug.
1
Place Bowl Lift Lever in down position.
2
W11456999A_01_EN.indd 8W11456999A_01_EN.indd 8 12-08-2020 14:32:4612-08-2020 14:32:46
To Next Page
Loading...
