KitchenAid 5KSS1121 - Assembly and Installation; Installing the SodaStream CO₂ Cylinder

10
ASSEMBLING THE SPARKLING BEVERAGE MAKER USING THE SPARKLING BEVERAGE MAKER
* The 60 L SodaStream Cylinder produces up to 60 litres of sparkling water, depending
on the level of carbonation.
2
Remove seal and cap from SodaStream
CO
2
Cylinder. Insert 60 L* SodaStream
CO
2
Cylinder into the Sparkling
Beverage Maker. First tip downward
into the base and then push upward
into the valve fitting.
Installing the SodaStream CO
2
Cylinder
Before First Use
Place the Sparkling Beverage Maker on a
flat, sturdy surface, in an upright position.
Remove packaging materials.
The Sparkling Beverage Maker uses
3 AAA batteries. To replace batteries,
see the “Care and Cleaning” section.
3
Turn the SodaStream CO
2
Cylinder
counterclockwise until it stops.
Hand-tighten only.
4
To reinstall back cover: tilt back cover
toward you; insert bottom tab into slot
and push cover into place.
1
To remove back cover: Grasp back
cover and pull away from unit. Set
cover aside.
W10624164A_FINAL.indd 10 7/2/14 9:13 AM