7
ENGLISH
3. Align the pitcher tabs with the slots of
the locking collar.
4. Press down and rotate pitcher
clockwise, approximately 1/4 turn until
two clicks are heard.
5. Align the pitcher tabs with the slots of
the locking collar.
6. Put pitcher assembly onto the Blender
base.
Preparing the Blender for Use
Before First Use
Before using your Blender for the first
time, wipe Blender base with a warm
sudsy cloth, then wipe clean with a damp
cloth. Dry with a soft cloth. Wash pitcher,
lid, locking collar and blade assembly,
sealing ring and ingredient cup in warm,
sudsy water (see "Care and Cleaning").
Rinse parts and wipe dry.
Blender Assembly - Glass Pitcher
(on some models)
1. Put locking collar with blade assembly
pointing up on a sturdy surface.
2. Put sealing ring, flat side down,
around the blades and into the groove
within the locking collar.
Sealing
Ring
Locking
Collar
To Next Page
Loading...
Need help?
General
