KitchenAid KDTM354ESS Installation Instructions

7
INSTALLATION INSTRUCTIONS
Prepare Cabinet Opening—
Existing Utilities
When removing a previous dishwasher, be sure to avoid
damaging the existing power cord, drain line, and water line
connected to the dishwasher.
If the water line and the cable extend to the locations shown,
proceed to the “Install Drain Hose” section. If they do not reach far
enough, follow the instructions in the “Prepare Cabinet Opening—
New Utilities” section.
Prepare Cabinet Opening—New Utilities
Prepare And Route The Electrical Supply
Option A, Power Cord:
NOTE: A grounded 3 prong outlet is required inside a cabinet next
to the dishwasher cabinet opening.
Drill a 1¹⁄₂" (3.8 cm) hole in cabinet side or rear. See the “Product
and Cabinet Opening Dimensions” section.
WARNING
Disconnect electrical power at the fuse box or circuit
breaker box before installing dishwasher.
Failure to do so can result in death or electrical shock.
Electrical Shock Hazard

KitchenAid KDTM354ESS Specifications

General

Style	built-in dishwashers
Color	black
Load Capacity	15
Number of Cycles	6
Cycle Selections	express wash, light/china, normal, prowash, rinse only, tough
Options/Settings	1-24 hour delay, control lock, heated dry, hi temp wash, prodry, proscrub, sani rinse
Noise level	44 decibels adjusted
Delay Start	yes
Number of Racks	2
Water Filter	yes
Sanitize Settings	yes
Smart Home	no
Annual Energy Consumption	270 kilowatt hours
Voltage	120 volts
Current	15 amperes

Weight and Dimensions

Depth	24 3/4 inches
Height	34 1/2 inches
Width	23 7/8 inches
Net Weight	102.1 pounds