In the State of Massachusetts, the following installation instructions apply:
• Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
the State of Massachusetts.
• If using a ball valve, it shall be a T-handle type.
• A flexible gas connector, when used, must not exceed 3 feet.
Anti-Tip
Bracket
Range Foot
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation instructions.
Slide range back so rear range foot is engaged in the slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed and engaged.
Failure to follow these instructions can result in death or serious burns to children and adults.
To verify the anti-tip bracket is installed and engaged:
• Slide range forward.
• Look for the anti-tip bracket securely attached to floor or wall.
• Slide range back so rear range foot is under anti-tip bracket.
• See installation instructions for details.
INSTALLATIONREQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Parts supplied
Check that all parts are included.
Tools needed
A
• Tape measure
• Flat-blade screwdriver
• Phillips screwdriver
• Level
• Hand or electric drill
• Hammer
• Wrench or pliers
• Pipe wrench
• 18/ls"combination wrench
• 1¼.drive ratchet
• 3/8"nut driver
• 1/8"(3.2 mm) drill bit (for
wood floors)
• Marker or pencil
• Pipe-joint compound
resistant to LP gas
• Noncorrosive leak-detection
solution
For LP/Natural Gas
Conversions
• 3/8"combination wrench
• 1/2"combination wrench
• 8/8"combination wrench
• 7 mm (8/32")nut driver
• Quadrex ®tor Phillips
screwdriver
• Masking tape
B
!
A. Anti-tip bracket
B. #12 x 1_" screws (2)
Anti-tip bracket must be securely mounted to floor or wall.
Thickness of flooring may require longer screws to anchor
bracket to floor.
Parts needed
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See "Electrical Requirements" and
"Gas Supply Requirements" sections.
1-@QUADREX is a registered trademark of NLW Holdings, Inc.
To Next Page
Loading...
