EasyManua.ls Logo

KitchenAid KIRD862VSS - User Manual

KitchenAid KIRD862VSS
60 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
LI3ZTB/W10342489F
30" (76.2 CM) AND 36" (91.4 CM)
RETRACTABLE (POP-UP) DOWNDRAFT
VENT SYSTEM
Installation Instructions and Use & Care Guide
For questions about features, operation/performance, parts, accessories, or service in the U.S.A., call: 1-800-422-1230
or visit our website at www.kitchenaid.com.
In Canada, call: 1-800-807-6777, or visit our website at www.kitchenaid.ca.
SYSTÈME DE VENTILATION RÉTRACTABLE
(CLAPET) DE 30" (76,2 CM) ET 36" (91,4 CM) –
ASPIRATION PAR LE BAS
Instructions d’installation et Guide d’utilisation et d’entretien
Pour des questions à propos des caractéristiques, du fonctionnement/rendement, des pièces, accessoires ou dépannage, composer le :
1-800-422-1230 ou visitez notre site web à www.kitchenaid.com.
Au Canada, composer le : 1-800-807-6777 ou visitez notre site web à www.kitchenaid.ca.
IMPORTANT: READ AND SAVE THESE INSTRUCTIONS.
FOR RESIDENTIAL USE ONLY.
IMPORTANT : LIRE ET CONSERVER CES INSTRUCTIONS.
POUR UTILISATION RÉSIDENTIELLE UNIQUEMENT.

Table of Contents

Questions and Answers

  • M
    Maria ThomasAug 10, 2025
    What to do if my KitchenAid Ventilation Hood blower does not operate?
    • D
      djonesAug 10, 2025
      If the blower on your KitchenAid Ventilation Hood isn't working, there are a few things to check. First, confirm that the vent is fully raised to the up position. Also, ensure that the filters are installed correctly by pushing them in as far as they can go to activate the switch behind them. Finally, verify that the control slider has been moved from the Off position; adjust it to control the blower motor speed. If the blower is not installed correctly, see the 'Rear Mounting – Blower Motor' section.
  • A
    Adam PowellAug 15, 2025
    Why is my KitchenAid KIRD862VSS not working?
    • W
      waltonshawnAug 15, 2025
      Your KitchenAid Ventilation Hood might not be operating due to several reasons. First, check if a household fuse has blown or a circuit breaker has tripped; if so, replace the fuse or reset the circuit breaker. If the problem persists, it's best to call an electrician. Another potential cause is that the filters are not seating correctly in the plenum. Ensure the filters are fully depressing the filter switches. Finally, make sure you have pressed and held the Start button for at least 3 seconds to initiate the cycle.
  • S
    Sean PearsonAug 20, 2025
    Why won't my KitchenAid KIRD862VSS retract?
    • A
      annapetersAug 20, 2025
      If your KitchenAid Ventilation Hood isn't retracting, it could be due to a few reasons. Ensure the filters are properly installed, as the vent system will not operate without them. Make sure the filters are pushed in completely to activate the microswitch. Also, the Start button needs to be pressed and held for at least 3 seconds to start retracting. Finally, check that the downdraft is correctly secured; it should be level, upright, and securely fastened to the floor and countertop.
  • P
    paigelittleAug 25, 2025
    How to fix a KitchenAid KIRD862VSS Ventilation Hood that is not level?
    • A
      Adam KnightAug 26, 2025
      To fix a KitchenAid Ventilation Hood that is not level on the countertop: * First, level the vent. * Second, make sure both of the support legs have the same height from the bottom of the vent box to the bottom of the support legs. See the 'Install Vent System' section.
  • F
    Felicia HoustonAug 30, 2025
    What to do if KitchenAid KIRD862VSS Ventilation Hood raises partially?
    • M
      mcopelandAug 30, 2025
      If your KitchenAid Ventilation Hood only raises partially, first ensure the cooktop is not interfering with the downdraft vent movement. Also, make sure the vent is level. See the 'Install Vent System' section.
  • R
    Rodney AlvaradoSep 4, 2025
    Why is my KitchenAid KIRD862VSS Ventilation Hood making noises?
    • R
      Robin GonzalezSep 4, 2025
      If your KitchenAid Ventilation Hood is making noises, especially grinding noises after a recent installation, use stainless steel cleaner to remove any residue left by the white protective film. Also, ensure the installation of the product is fully into the cutout with no gap in the middle of it, as noise can be caused by moving air.

KitchenAid KIRD862VSS Specifications

General IconGeneral
TypeDowndraft
Number of Speeds3
FinishStainless Steel
MaterialStainless Steel
ColorStainless Steel
Ventilation TypeDucted
Control TypeElectronic
Height18 in.
Depth12 in.
Width36 in.

Related product manuals