6
PRODUCT ASSEMBLY
NOTE: When properly positioned, the pitcher will rest completely on the Blender base. If
not, repeat step 2. Make sure the pitcher is properly locked onto the Blender base.
IMPORTANT: When moving your Blender, always lift from the Blender base.
Base will become disengaged from pitcher if carried by Blender pitcher or Blender pitcher
handle only.
Adjust the length of the Blender power
cord.
1
Align the pitcher tabs with the slots on the
base.
Rotate the pitcher, approximately 1/8 turn
until it clicks into the place.
Tab
Slot
2
Put ingredients in the pitcher and firmly
place lid.
3
Plug the Blender into a grounded 3 prong
outlet, and press POWER. The Power
indicator light will flash when ready.
4
WARNING
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
W11382496A.indb 6 8/7/2019 4:44:54 PM
To Next Page
Loading...
Need help?
General
