TROUBLESHOOTING
Juicer does not operate when turned on
Motor sounds strained during operation
Build-up of excess pulp in the ceramic disk
Pulp is too wet; not enough juice being extracted
Juice is spraying out of the spout
Cleaning tips
• Check to make sure the Juicer has been
assembled correctly, and the lid is in the
locked position.
• Stop the juicing process and follow the
directions in the “Care and cleaning”
section to disassemble and clean the
juicer lid. Scrape off pulp, reassemble, and
resume juicing.
• Try a slower speed and push ingredients
more slowly through the feed tube.
• The wrong speed was selected for
ingredients being juiced, putting excess
strain on motor.
• After each use, immediately rinse all
removable parts in hot water to remove
pulp and juice. It may be necessary to use
the cleaning brush to remove pulp from
the screen. Let parts air dry.
• To prevent staining of plastic parts from
brightly colored fruit and vegetables, wash
parts immediately after use.
• If discoloration from ingredients occurs,
soak plastic parts in a solution of water
and 10% lemon juice. You can also clean
them with a non abrasive cleanser. Do not
soak plastic parts or ceramic disc in bleach
to remove stains.
• Refer to the Speed Selection Table in
the “Tips for great results” section to
determine the correct juicing speed for
your ingredients.
• Once excess pulp is removed, try
alternating between soft and hard
vegetables and fruit.
• Juicing screen may be clogged. Follow
directions in the “Care and cleaning”
section to disassemble Juicer and clean
the screen.
• Check your pulp setting. You may need to
change it based on your preferred juice
thickness.
• Make sure juice pitcher is pushed close to
the juicer and ts snugly against it.
W10673583C_ENv01.indd 17 9/3/14 4:21 PM
To Next Page
Loading...
