KitchenAid SUPERBA KEBS176 - Page 35

• Combining the Delay and
Extended Self-Clean Cycle Options
An automatic Self-Clean cycle can be both delayed and ex¬
tended if desired. Follow steps 1, 2, 3 and 4 under "TO
START THE AUTOMATIC SELF-CLEAN CYCLE," then;
1. Set the delayed start time by turning the TIME knob
until the new start time appears in the Display
Window.
2. Touch the START button to lock in the new start time.
The display will show "STOP TIME" and the automatic
preset cleaning stop time. Turn the TIME knob until
the new cleaning stop time appears in the Display
Window.
3. Touch the START button again to lock in the new stop
time and return the clock to the present time of day.
4. "AUTO" will flash in the Display Window until the
cleaning cycle begins. Once the cycle is in progress,
"AUTO" will appear continuously. No end of cycle tone
will be given.
What Happens During the Self-Clean
Cycle?
After the controls have been set on a non-delayed cycle, or
after the delayed time has run out on a delayed cycle:
• The Power On Light will glow to tell you the oven is
"ON."
• The Clean and Oven Lights will glow to teU you the oven
is slowly heating to the clean temperature, and "AUTO"
will appear continuously in the Display Window,
• The Lock Light will come on when the temperature
reaches 575-600°F (approximately 15 minutes).
At the End of the Cleaning Cycle
• The Oven Light win go out.
• The Clean Light will go off.
• The Lock Light will continue to glow until the oven
temperature drops below 550° F. The oven door cannot be
opened until Lock Light goes out.
• After a clean cycle, any powdery residue can be wiped
away with a damp cloth. If white spots remain in the
oven after a clean cycle, remove them with a non-scratch
scouring pad before using the oven again. These spots are
usually salt residues that cannot be removed during the
Self-Clean cycle.
• If the soil removal was not complete, increase the length
of the clean time in the next cycle.
36