13. Move the co sleeper next to the
parents bed and check the height of
the co sleeper compared with the
mattress on the bed. Fig 13.
The side support of the co sleeper
should always be placed close to the
parents mattress. The mattress should
always be aligned with the height of
the side support to restrain the co
sleeper.
14. To x the co sleeper to the parents
bed in bedside sleeping mode, use
the pair of xing belts provided. Slide
the straps between the
mattress and the bed base using a
back and forth ‘sawing motion’ and at
the same time pulling downward until
the straps and anchor plates are in
the desired position. Fig 14.
15 The anchor plates should look like
this once they are assembled
between the mattress and the base.
Fig 15.
CAUTION! Ensure the xing belts are
straight
1 Tighten the loop by pulling the belts
rmly. Fig 16.
Adjust the belts separately until the
sleeper is rmly in contact with the bed
mattress.
Store any excess of belts between the
mattress and the bed base.
Fig 13
Fig 14
Fig 15
Fig 16
To Next Page
Loading...