Kitvision escape - Instructions for Use; Turning Power On and Off; Charging the Battery

12 13
Using time lapse mode
1. Turn on the camera and press the Power/Mode Button (3) to enter the Settings Mode.
2. Scroll down the Settings menu and select ‘Time Lapse’, and use this option to select the time
period between each photo.
3. Return to the Setting menu and choose ‘Continuous Lapse’ and select ‘ON’.
4. Exit the Settings menu by scrolling up or down until the cross in the top right corner is highlighted
and press the Shutter/Ok Button (1) to exit.
5. Press the Power/Mode Button (3) three times to select Timer Mode.
6. Use the Built-in LCD (10) to view your shot, and then press the Shutter/Ok Button (1) to activate
theTimeLapsephotosequence.AteverysetintervaltheBuilt-inLCD(10)willashandthe
camerawillsounda‘Beep/Shutter’soundeect.
7. The camera will continue to take a photo at every interval until deactivated by pressing the
Shutter/Ok Button (1) again.
Using playback mode
1. Turn on the camera and press the Up Button (11) and choose Video Playback or Photo Viewer.
2. TonavigatethroughyourlesusetheUpButton(11)andDown/Wi-FiButton(13).
Viewing video les
1. OnceavideoleisselectedpresstheShutter/OkButton(1)toplay.
2. WhilstplayingthevideoleyoucanrewindbypressingtheUpButton(11)orfastforwardby
pressing the Down/Wi-Fi Button (13).
3. Whilst playing the video you can pause by pressing the Shutter/Ok Button (1).
4. Press the Power/Mode Button (3) to return to the selection screen.
Removing the battery
1. Lift the Battery Cover (14) by lifting the Battery Cover Latch (15).
2. Pull the battery tab to remove the rechargeable battery.