10 11
Using video mode
1. Turn on the camera and it will start in Video Mode. If in another mode, press the Power/Mode
Button (3) until you reach Video Mode.
2. Use the Built-in LCD (10) to view your shot, then press the Shutter/Ok Button (1) to start recording.
3. WhenrecordingtheTopOperationIndicator(2)willash,theLCD(10)willshowaredvideoicon
and will display how long it has been recording for.
4. Press the Shutter/Ok Button (1) again to stop recording.
Note: The camera will stop recording and save automatically when the memory capacity is full or
it has run out of battery power.
Recording audio within a video
If using the camera with the waterproof case, audio will be recorded although it will be less audible.
Forbestaudioquality,thecamerawillneedtobeusedwithoutthecase.Whenusingthecamera
without a case, please take extra care and make sure it does not get wet.
Using photo mode
1. Turn on the camera and press the Power/Mode Button (3) once to select Photo Mode.
2. Use the Built-in LCD (10) to view your shot, and then press the Shutter/Ok Button (1)
to take a still image.
3. Aftertheimagehasbeentaken,thecamerawillmakea‘shutter’soundeectandthe
Built-in LCD (10) will blink once.
Using burst mode
1. Turn on the camera and press the Power/Mode Button (3) twice to select Burst Mode.
2. Use the Built-in LCD (10) to view your shot, and then press the Shutter/Ok Button (1) to take three
stillimages.Thecamerawillmakeaseriesof‘shutter’soundeectsdependingonthequantity
ofphotosselected,andtheBuilt-inLCD(10)willturnblackduringthissequence.
Using timed mode
1. Turn on the camera and press the Power/Mode Button (3) three times to select Timer Mode.
2. Use the built-in LCD (10) to view your shot, and then press the Shutter/Ok Button (1) to activate the
timer. The built-in LCD (10) will blink and the countdown will start. At the end of the countdown the
Built-inLCD(10)willashandthecamerawillsounda‘Beep/Shutter’soundeect.
To Next Page
Loading...
