Kitvision Immerse 360 Duo - Getting Started with Immerse 360 Duo; Charging the Camera; Memory Storage Card Setup; Powering the Camera On and Off

4 5
Instructions for use
Charging the camera
The camera has a built-in rechargeable Lithium-Ion battery. Please fully charge the camera before use.
1. Ensure that the camera is turned o.
2. Open the USB/ Micro SD Card Port (10) and connect the micro USB connector of the USB cable
to the camera USB port and the other end to a PC/mains charger USB port.
3. The Power LED/Charging LED (4) will be solid blue whilst charging.
4. Once fully charged, the Power LED/Charging LED (4) will turn o.
Note: The camera body will be warm when charging and after extended use. This is normal.
Memory storage card
The Immerse 360 Duo doesn’t have any internal memory. To be able to record video or capture photos,
you must have your micro SD card inserted.
1. Ensure the camera is turned OFF.
2. Open the USB/ Micro SD Card Port (10) and insert your memory card into the micro SD card slot.
You will need to format your micro SD card to FAT32 with a default le size allocation.
We recommend using a Class 10 micro SD memory card between a minimum of 8 GB
and a maximum of 32 GB.
Note: Always turn o the camera when removing or inserting a micro SD card.
Turning power ON/OFF
1. To turn ON, press and hold Power/Mode (2) for about 2 seconds, until the camera beeps. The Power LED (4)
will turn red, and the LCD Screen (1) will illuminate to show the ‘Welcome’ screen. This will then change to the
home screen.
2. To turn OFF, press and hold Power/Mode (2) for about 3 seconds and release when the camera beeps.
The LCD Screen (1) will show the ‘Goodbye’ screen and then turn o.
Power saving mode
1. If the camera isn’t used for 1 min (default setting), the camera will enter Power Save mode. The LCD Screen (1)
will turn o automatically. The camera can be re-activated by pressing any button.
2. If the camera isn’t used for 3 mins in Power Save mode, the camera will automatically turn o.