Kkmoon TS-838 - Overview of functions

30 31
Overload
-
OVERLOAD
1.
OVERLOAD
.
2.
3.
4.
5.
6.
7.
1.
2.
E44395_Power meter_PT_IM_PRINT.indd 30-31
Other functions (for
professional)
Adjust the values of the overload
When one of the values of overload is ultra-past
appears on the display
blinking
and the device sends a beep.
Hold the button VALUE H/+ to
appear
on the display.
Hold down the SET button for
about 3 seconds.The display flashes to
indicate to the amps, or W for watts.
With the buttons VALUE H/+ or
DISPLAY M / -
Press again the SET button. The first digit in
the display flashes.
snottub eht htiw seulav derised eht teS
VALUE H+/ or DISPLAY M / -.
With the SET button can go to the next digit
and regulate it the same way.
At the end confirm the introduction of
.nottub KO eht htiw seulav
daehrevo fo seulav eht eteleD
Press the VALUE H / + until Amax
(maximum current) and Wmax (maximum
power) on the display.
Hold down the OK button to the
provi-tive beeps. The value of the
corresponding on-load is then removed.
Power Factor
The power absorbed by a consumer in W is
calculated from the current in A multiplied by the
voltage V with the following formula:
P [W] = U [V] * I [A]
In the case of appearance of capacitive or
inductive consumer occurs, however,
With this function you can determine in
which current value (16 in max) or power:
5 WAT-cia (3680 W Max.) the appliance
shall issue a overload warning.