l abc
Identification of controls:DN9344
Section 1 input metering
incorporating multi-point clip
indication. This meter indicates the
level immediately after the input gain
trim.
Section 1 output metering
incorporating multi-point clip
indication. This meter indicates the
actual output level from the unit, while
the red clip light indicates internal
clipping, which is monitored at every
internal processing stage.
Section 1 dynamic EQ
metering. Four separate meters are
provided, to allow continuous
monitoring of all dynamic EQ
sections.
Remote Control Active indicator (green) for Channel 1A, 1B,2A and 2B. This shows that the master unit is currently
controlling this channel by remote control. These green lamps are often referred to as the “me” lights.
Display mode indicator (blue) for
Section 2. When lit this indicates that
the large red displays are now showing
Last Memory Recalled and
Communications Mode. When not lit,
the displays are showing electronic
scribble-strip names. In this case the
left-hand three characters show the
name of Channel A and the right-hand
three the name of Channel B, for each
of the two sections.
UP and DOWN keys for Section 2.
Used to select communications
channel (address) for remote control
and also contact closure mode.
Active only when in SETUP menu
(press and hold SETUP to enter this
menu).
T-DEQ
38
To Next Page
Loading...
Need help?
General
