Klarstein 10017162 - Compressor Protection; Water Drainage; Maintenance; Trouble Shooting

13
Compressor protection
• Three minutes later after power on / restart, compressor starts to run.
Water Drainage
This machine with auto-water-evaporating system. Condensed-water cycle to cool down the
condenser, which will not only improve cooling eciency, but also save energy.
• If inner water tank is full, “
”willashedonthescreen,machineenterintostandbymode,
buzzer shouts , compressor stops and all keys is invalid till machine recovers to be normal.
• Pullouttheplugtodrainoutwater,powerothemachineandrestartit,themachinewillruns
normally.
Maintenance
Note: in order to avoid electric shocks, please power-o the machine and pull out plug before
maintenances or repairs.
Cleaning
• Please pull out plug before cleaning .
• Use soft semi-dry cloth to clean the machine. Don’t use chemical agents, such as benzene,
alcohol, gasoline and so on ; otherwise the machine surface will be damaged, or even the machine
itself.
• Don’t spatter water into the machine .
Filter
• Cleanthelterseverytwoweeks,ifltersareblockedbydust,machineeciencywillbereduced.
• Cleantheltersinwarmwaterwithneutraldetergent,thendrythecleanedltersonashady
place.
Note:Don’trunthemachinewithoutlters.
Season Cleaning
If the machine will be unused for a long time, please do as following:
• Pulloutdrainageplugtoowoutwater.
• Let the machine runs under fan mode for 2 hours to dry out the machine internal
• Turnomachineandpulloutplug.
• Cleananddrylters,thenreinstallthem.
• Pull out exhaust pipe for safekeeping .
• Put the machine into plastic bag , and place it on a dry place.
Trouble Shooting
Please contact professional serviceman without delay in following situation
Trouble Cause Solution
Machine cannot work
Powero Power on
Water-full indicator turns on Drain water out