ERROR CODES AND TROUBLESHOOTING
Code State Suggested Solution
E01 “E01” on LCD is ashing. Something goes wrong with
the appliance. It must be sent
to the approved service centre
for repairing.
E02 “E02” on LCD is ashing. The
bowl wasn’t installed.
Install the bowl according to
the operating instruction.
E03 “E03” on LCD is ashing. Install it according to the
operating instruction.
E04 “E04” on LCD is ashing. The temperature of appliance
is too hot. Firstly let it cool
down 30 minutes to 2 hours,
and then reboot it. It must be
sent to the approved service
centre for repairing if the
previous cooperation doesn’t
work.
-- LCD is ashing. Press”Start/Stop” button
longer than 3 seconds to
recover it.
To Next Page
Loading...
