47
EN
CLEANING
• Before cleaning the air conditioner, switch it off and disconnect the power
supply for at least 5 minutes, otherwise there is a risk of electric shock.
• Do not use petrol, benzene, thinner or other chemicals or liquid insecticides
on the air conditioner, as these substances may cause the paint to peel, crack
or deform plastic parts.
• Never attempt to clean the unit by pouring water directly on any of the
surface areas as this will cause deterioration of the electrical components and
wiring insulation.
Clean the unit
When the unit is contaminated, clean it gently with a wrung towel using tepid
water below 40 °C (104 °F).
Clean the air lter
1. Remove the grid and take out the upper air lter.
2. Clean the air lter
Use a vacuum cleaner or water to rinse lter, and if the lter is very dirty (for
example, with greasy dirt), clean it with warm water (below 40°C{104"F)) with
mild detergent dissolved in, and then put the lter in the shade to dry in the
air.
3. Reinstall the dried lter in reverse order of removal. Put the lter cover back
to its place.
Note: if you don't use the unit for a long time, please
pull out the rubber plug to drain the inside water out
referring to right gure.
To Next Page
Loading...
