Klarstein AERO RING SMART - Operation

40
EN
OPERATION
WARNING
Failure to observe the following precautions may result in
electric shock, re or personal injury.
1.The plug must be connected to a properly installed and
grounded outlet.
2. Do not use an extension cord or plug adaptor with this unit.
Before starting the unit
1. Select a suitable location, making sure the unit is near an electrical outlet.
2. Fit the exible exhaust hose and the adjustable window slider kit.
3. Plug the unit into a mains socket
Cooling operation mode
1. Press the MODE button repeatedly until the Cooling indicator lights up.
2. Set the desired temperature by pressing the “+“ or “-“ button.
3. Press the FAN button to select the fan speed.
Drying operation mode
1. Press the MODE button repeatedly until the Dry indicator lights up.
2. The fan runs at a xed speed in this mode.
3. Press the FAN button to select the fan speed.
Note: The setting temperature and fan speed can not be adjusted.The setting
temperature is 25'C (77°F) and the fan speed is low.
Fan operation mode
1. Press the MODE button repeatedly until the fan indicator lights up.
2. Press the FAN button to select the fan speed.
Note: The set temperature cannot be adjusted.
Auto-restart function
If the power supply to the unit is interrupted, the unit restarts in the mode/
settings last used when the power is restored. The compressor restarts after 4
minutes.
1. Set: Press the sleep button 10 times within 5 seconds, the buzzer will sound 4
times.
2. Cancel: Press the Sleep timer key 10 times within 5 seconds, the buzzer will
sound twice.