Klarstein alchemist - Greasing the gas valves; TROUBLESHOOTING

35
EN
Greasing the gas valves
Over time, the gas valves may be stocked, and it is difcult to turn on/off. For this case,
should clean the inside of valve and greased it.
Kind reminder: This procedure must be performed by a technician authorized by the
manufacturer.
TROUBLESHOOTING
Problem Check to make sure that:
The burner cannot be lighted or the ame
is not uniform around the burner.
• The gas holes on the burner are not
clogged;
• All of the movable parts of burners are
xed correctly;
• There is no air ow around the
cooking surface
The ame does not keep lighting to the
burner with thermocouple
• You press the knob all the way;
• You keep pressing the knob
for enough time to activate the
thermocouple.
• The gas holes are not clogged
in the area corresponding to the
thermocouple.
The ame goes out while turning knob to
"Low" setting.
• The gas holes are not clogged.
• There is no air ow around the
cooking surface.
• The minimum has been adjusted
correctly (see the section entitled
"Minimum Regulation").
The cookware is not stable. • The bottom of the cookware is
perfectly at.
• The cookware is centred correctly on
the burner.
• The support grids have not been
inverted.